Wednesday 19/9/2018

Bookmark and Share
 
 
Case Studies
  PandCT RSS Case Studies feed
CHOPPER PUMPS HELP FORD MOTOR TO IMPROVE WASTE HANDLING

2 February 2012

The Ford Engine plant in Dagenham is not the type of site you usually associate with an application for a VAUGHAN chopper pump as these powerful, heavy-duty pumps are more likely to be found operating at sewage treatment works around the UK. However, motor manufacturing, like any major process involves its own unique solids pumping challenges. For example, how to handle the difficult combination of swarf, cutting oils and coolants being collected from huge CNC machines operating on engine and transmission manufacture.

The origins of the application began in the late 1990’s when Vaughan Co. supplied an initial trial pump to a Michigan based OEM filter systems manufacturer. The pump was to be tested to see how it would perform against the conventional method of handling waste material and coolant collected from CNC machines. The design and operational characteristics of the Vaughan pump provided an effective, all-in-one combination of shredder and pump which could handle all the ingredients of the machine waste, affectionately known as ‘pump backs’ in the industry.

After 4 years of validation and ongoing collaboration between Vaughan, the filter  systems engineers and Ford Motor Company’s transmission and coolant specialists, Vaughan succeeded in being chosen as the preferred type of pump for the waste handling applications.

Fast forward to 2005 and Vaughan’s Huntingdon based UK distributor P&M Pumps became involved with the supply of 74 bespoke design V3M ‘pump back’ pumping systems for similar waste handling applications at Ford’s UK engine plant sites at Dagenham and Port Talbot.

These pumps were supplied from Detroit and then the packaged system was fabricated and built in the UK by P&M Pumps. They were then shipped to the German CNC manufacturer for eventual delivery and installation at the Ford UK sites. Today, approximately 175 Vaughan pumps are, in the words of Ford Motor Company’s engineers, “performing flawlessly” on the waste handling pump applications associated with their huge machine tool process.

Through their experiences at numerous UK waste water treatment and manufacturing sites, P&M Pumps have been able to demonstrate that Vaughan Chopper Pumps are an extremely effective option on the most challenging solids pumping applications.

Further information on Vaughan Chopper Pumps is available from; Matt Harvey,

P&M Pumps
, Sawtry, Huntingdon, UK. Tel: 01487 830123. Fax: 01487 832888.
sales@thesolidsolution.co.uk      www.pandmpumps.co.uk
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=31808

Company gateway pages
for P & M Pumps:
FREE Information on the products in this article
To request more information from this supplier,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2018 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy