Thursday 28/5/2020

Bookmark and Share
 
 
Product Focus
  PandCT RSS Product Focus feed
Mantracourt Introduces an Interface Module for the SGA Load Cell Conditioner

26 September 2012

Bridge Completion Module Enables Broader Application of Strain Gauge Amplifier

Mantracourt have announced the release of a Bridge Completion Module (SGABCM), a small retro-fit PCB which facilitates connecting a half or quarter-bridge strain gauge to their SGA Load Cell conditioner.

An important feature of the Bridge Completion Module is that it is easily installed. It simply screws into the existing load cell connector on the SGA amplifier module. It also has on-board screw terminal connections that accept a wide range of bridge completion resistors, enabling on-site installation without soldering equipment.

Mantracourt's market leading SGA Strain Gauge Amplifier is a high performance signal conditioner for single or multiple strain gauge bridge sensors such as load, force, pressure and torque. The SGA offers a wide bandwidth and a wide input signal range. The device can be powered from AC or DC supplies providing excitation for up to 4 x 350 ohm strain gauge bridges.

"In many ways, this is a small and simple device, but it is enabling engineers to connect an increasingly diverse range of sensors to our amplifier module," said Kelly Voysey, Sales and Marketing Manager at Mantracourt. "The Bridge Completion Module is a good example of how our engineers are working with instrumentation professionals around the world, helping to develop truly effective measurement technology."


UK based Mantracourt is a leading manufacturer of industrial measurement technologies and a world leader in the design and manufacture of electronics for measurement technologies, including strain gauge, temperature, resistance, pressure, voltage, current, potentiometer, rate, flow, LVDT and displacement in either analogue, digital or wireless form.

The quarter bridge strain gauge circuit, together with its completion resistor can be wired for compression or tension (stretching) giving a positive output and half bridge strain gauge devices are simply connected to the BCM module via the screw terminals, with no additional components required.

The Bridge Completion Module has high stability resistors (5ppm/°C) fitted for the ‘fixed’ arms of the bridge, and screw terminals are provided for a ‘Shunt Calibration’ shunt resistor to be fitted, to periodically check the integrity of the strain gauge(s), wiring and calibration. A ‘Remote Shunt Calibration’ can be performed by energising a miniature 24V relay fitted to the BCM. Multiple SGAs in an installation can be shunt calibrated simultaneously.

For further information, please contact Kelly Voysey :

Mantracourt

tel: +44(0)1395 232020
marketing@mantracourt.co.uk
http://www.mantracourt.co.uk
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=34352

Company gateway pages
for Mantracourt Electronics Ltd:
FREE Information on the products in this article
To request more information from this supplier,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2020 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy