Saturday 17/11/2018

Bookmark and Share
 
 
Product Focus
  PandCT RSS Product Focus feed
New field connections for Profibus

30 October 2013

New range of Profibus splitters launched by ifm electronic

The choice of field connections for Profibus DP users is increased with the launch of the new FieldModuleDP range from leading sensor manufacturer ifm electronic.

In all seven devices on offer, all are fully compliant with the Profibus standard IEC 61158 (DP V1) for configuration and diagnosis.

FieldModuleDP provides a compact and rugged connection block, with IP67 rating, for inputs and outputs, either analogue or digital.

One of the most interesting of the FieldModuleDP range is the AC2625. This is equipped with IO-Link, the latest technology for low-level communication with devices in the field. IO-Link takes the bus the ‘last metre’ where previously the field node was the last stop on the bus.

The number of devices with IO-Link built in is increasing rapidly, and so is their take-up, as users realise the advantages of the transparency, ease of configuration and flexibility offered by the technology. IO-Link transmits not only digital, but also analogue signals from an IO-Link device directly as values, greatly reducing conversion losses from the original measured value to 4 to 20 mA and back again.

The AC2625 provides four connections for IO-Link devices and, in common with the others in the range, has an additional port for optional external power as well as the Profibus DP in and out connections, yet is still only 30mm wide and 210mm long so none of these modules will take up much space.

Other units in the range offer standard digital inputs and/or outputs. Analogue inputs (current or voltage), analogue outputs (current) are featured in other versions; while another, the AC2634 can accept inputs directly from Pt100 temperature probes. Using the AC2634 means than almost any Pt100, with two, three or four wires, can be connected to Profibus DP without the need for specialised cards.

The FieldModuleDP range from ifm electronic provides Profibus DP users with simple, cost-effective methods of combining a wide variety of field devices with this widely-used bus system.

ifm is committed to working closely with its customers to develop products which precisely match their needs, and the company provides expert, readily accessible technical support to help users maximise the benefits they gain from ifm products.

For further information, contact:

Gemma Anderson
ifm electronic Ltd
efector House
Kingsway Business Park
Oldfield Road
Hampton
Middlesex
TW12 2HD

Tel:  020 8213-0000. 
Fax:  020 8213-2234.
Email: gemma.anderson@ifm.com.
Web:  www.ifm-electronic.com
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=38700

Company gateway pages
for ifm electronic ltd:
FREE Information on the products in this article
To request more information from this supplier,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2018 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy