Thursday 9/7/2020

Bookmark and Share
Daily News
  PandCT RSS Daily News feed
Latest pipeline collapse shows urgent need for two-way Air Valves

22 April 2016

The catastrophic collapse of a pipeline at a $10M project in Central America is clear proof that current procurement of Air Valves needs to be urgently reviewed.

Craig Stanners, Director of IVL Flow Control (part of Ham Baker Group) said: “This latest incident was actually caused by not having any air valves at all (!), which was a disastrous oversight by the consultant. In an increasing number of cases it is not the end-user or the contractor at fault. It’s a lack of understanding from consultants who don’t seem to understand that when you are putting water into a pipeline or draining out due to a burst, air must be let in – and let out”.

Stanners, who has been a key speaker at two recent Water Loss conferences in the U S and India says that the vacuum created by negative pressure in a system (caused by no air valves or the wrong type of air valves) is enough not just to destroy plastic pipelines, but tough metallic materials too.

He added: “The ludicrous recommendation by the consultants for this project in Central America to make do without Air Valves probably ‘saved’ around £7000. What an oversight. In the UK, there is a plague of cheap plastic Air Valves in the ground. These valves are a single, air-out only function, costing around £70. Instead, two-way valves (for air-in and air-out) should be installed, but because they’re closer to £170, procurement departments or consultants think they’re doing a great job with savings. Perhaps they could explain then why in the U S alone there is now $346 Billion worth of failing assets in the ground. I don’t call that much of a saving”.

Stanners said he was horrified to be quoting on one recent project when the asset manager had to admit that although the municipal company knew they had air valves, they didn’t know exactly where – only that the contractor had used ‘a load’ left over from a previous job. Subsequent failures with poor tap pressures was already producing numerous complaints from consumers, giving the water company concerned some very unwanted SIM points.

“In an age where anyone could use Google to get an idea of topography”, concluded Stanners, “it seems unforgiveable that some consultants aren’t even specifying air valves to be installed every 500m on just a straight length of pipe. And it’s madness too for those who do specify to then cut corners with cheap or unsuitable air valves. It is time to install the right, long-lasting product and stop adding to the stockpile of failed assets buried in the ground”.

For more information, please contact:

Craig Stanners
IVL Flow Control
Unit 1 & 2 Washington Ind Est
Washington St
West Midlands
Tel:  +44 1384 458411
Fax:  +44 1384 246952
Web: are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=45970

Company gateway pages
for IVL Flow Control:
FREE Information on the products in this article
To request more information,
fill in your email address below.
Your email address
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2020 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy