Tuesday 19/11/2019

Bookmark and Share
 
 
Daily News
  PandCT RSS Daily News feed
Forthcoming Webinar - Advances in Non-Contact Temperature Measurement in Metal Reheat Furnaces

29 April 2019

On 30th April 2019 at 3pm GMT, AMETEK Land introduces how advances in accurate non-contact temperature measurements in metal reheat furnaces ensure optimum product quality, reduced wastage, energy savings, consistent metallurgical properties and minimal surface scaling.

Reheat furnaces bring cold metal to the correct temperature for rolling, extruding or forging. For optimum quality, and to reduce wastage, the temperature should be uniform throughout the product, which requires accurate temperature monitoring.

In addition, temperature measurements are key to providing optimized heating trajectories for the metal, which results in significant energy savings, consistent metallurgical properties and minimal surface scaling.

Webinar attendees will learn the requirements and challenges for infrared temperature measurement in reheat furnaces, both continuous and batch, and will examine both traditional and next generation technologies.

The webinar will demonstrate how the most effective and accurate method of achieving these measurements is through continuous thermal imaging of the entire metal stock.

Key Takeaways

- Learn the fundamentals of non-contact temperature measurement and its use in metal reheat furnaces
- Understand the traditional and next generation sensors available for temperature measurement in the process
- Discover the quality, control and cost savings achievable by accurately monitoring temperature
- Learn the importance of continuous thermal imaging temperature measurement of the entire metal stock

Register for the Webinar

ABOUT THE SPEAKER

Manfred Hayk, Global Infrared (IR) Product Manager, AMETEK Land
With a Dipl.-Ing. (FH) in Physical Engineering, specializing in laser technology and optical metrology, Manfred Hayk has over 20 years of technical, product and application development and sales support experience in optical and infrared metrologies. He is AMETEK Land's Global Infrared (IR) Product Manager and is focused on developing AMETEK Land's full range of non-contact temperature measurement products, including process thermal imagers.

www.globalspec.com/events/eventdetails?eventId=2151

For more information, please visit: www.ametek-land.com
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=53404

Company gateway pages
for AMETEK Land (Land Instruments International):
FREE Information on the products in this article
To request more information,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2019 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy