Tuesday 10/12/2019

Bookmark and Share
 
 
Product Focus
  PandCT RSS Product Focus feed
CK ATRONIK INCREASES INTEGRAL CONTROL VERSATILITY OF ROTORK MODULAR ELECTRIC VALVE ACTUATORS

8 July 2019

Rotork has increased the versatility of the CK range of modular electric valve actuators with the introduction of the CK Atronik, an intermediate level integral control option, providing a ready-to-operate actuation solution to meet the standard requirements of many plant specifications.
The CK Atronik control module houses a reversing contactor starter with mechanical and electrical interlocking, a proven and reliable Rotork design for electric actuation. Connection to a suitable power supply is all that is required for local operation of the actuator.

Digital microprocessor driven functionality delivers reliable motor control for isolating, regulating or modulating valve duties. Configuration is simply achieved with on-board dual in-line switches. Integral local control selectors are provided, together with clear LED status indication of valve open, valve closed, valve moving and alarm. Mechanical valve position indication is also provided on the actuator gearcase. Options include analogue control for positioning, analogue feedback, additional relay and network bus connectivity.

All CK modular actuators are environmentally sealed to IP68 (8 metres for 96 hours) as standard for long-term reliability in harsh operating conditions. Plug and socket connections for power, control and between modules assist swift site wiring and maintenance. Manual handwheel operation is independent of the motor drive and selected with a lockable hand / auto lever acting on a safe, low speed clutch. Separate thrust or non-thrust bases are available, enabling removal of the actuator from the valve without affecting valve position.

CK Atronik actuators can be specified for operation from single-phase or three-phase electrical supplies. For three-phase supplies the maximum actuator output torque is 500 Nm (369 lbf.ft) in an output speed range of 9 - 230 rpm.

For more information, please contact:

Rotork plc
Brassmill Lane
Lower Weston
Bath
Avon
BA1 3JQ
Tel:  01225 733200
Fax:  01225 333467
Email: tony.scott@rotork.co.uk
Web:  www.rotork.com
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=53854

Company gateway pages
for Rotork plc:
FREE Information on the products in this article
To request more information from this supplier,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2019 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy