Wednesday 19/2/2020

Bookmark and Share
 
 
Case Studies
  PandCT RSS Case Studies feed
Flow Measurement in F1 Racing Cars

16 October 2019

High pressure flowmeters from Titan Enterprises have, over the last decade, been widely used in the hydraulic test systems of F1 racing cars to measure fluid flow. A high-performance engine company also uses Titan flow meters to monitor the oil flow lubricating its turbo units on the test bench.

Formula 1 engines typically have no cooling fans and therefore need to reliably run at temperatures in excess of 200°C. Measuring the high flow of coolant water at these elevated temperatures, without causing an undue pressure drop in the system, is another example of an automotive flow measurement development undertaken by Titan. Using the inherent very low pressure drop of their Oval gear flow meter design – Titan produced a 200°C, 50 L/minute flow meter with a pressure drop of less than 100mBar to solve this challenging application.

A few years ago, one racing team turned to Titan as it did not trust the fuel flow figures being returned from their engine suppliers fuel management systems. For this application a very lightweight oval gear flowmeter was designed to be installed safely in the fuel tank of the racing car. Designed to be immune to immersion in fuel and the
very noisy electrical environment of a racing car. this flowmeter has provided accurate flow measurement over an extended period of time.

In addition, a growing number of engine and car manufacturing companies have benefited from using Titan's Atrato ultrasonic flowmeter for both diesel and petrol measurement on test stands and in engine development. Because the Atrato does not have a contorted flow path. and fuel passes straight through the flowmeter. it can uniquely operate at the same bore as the fuel lines. This reduces the pressure loss and keeps “dead” fuel volume to a minimum.

Drawing upon over 40-years of flowmeter innovation - Titan Enterprises Ltd are a manufacturer of high-performance solutions including the Atrato ultrasonic flowmeter, Oval Gear flowmeters, low flow Turbine flow meters and a flow instrument range. Titan’s company philosophy of “pushing the envelope by trying to do things a little different and better” has resulted in sales of over 1,000,000 products into 50 countries worldwide and a repeat purchase percentage of 95%. All flow meters produced by Titan Enterprises are designed and manufactured to ISO9001 and calibrated to an uncertainty of ±0.25%.

For more information, please contact:

Titan Enterprises Ltd.
Coldharbour Business Park
Sherborne
Dorset DT9 4JW
UK
Tel:  +44-1935-812790
Email: sales@flowmeters.co.uk
Web:  www.lowmeters.co.uk
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=54521

Company gateway pages
for Titan Enterprises Ltd:
FREE Information on the products in this article
To request more information from this supplier,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2020 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy